stockholmviews.com

3D printer hardware test board build

Posted on January 14, 2023 by gregganMarch 8, 2023

This writeup is about how to use Klipper firmware on an old abandoned 3D printer mainboard to use as a test rig for 3D printer hardware. That was one of the longest headers that I have been written :o)
Klipper firmware can be installed on…

Bondtech V2 inspired “bowden” extruder THE OXtruder

Posted on January 4, 2023 by gregganMarch 8, 2023

The OXtruder may be the strongest extruder you might need, this design can be adapted to both 1.75 and 3mm filaments.

3D print annealing of PLA and HT-PLA

Posted on December 21, 2021 by gregganJanuary 4, 2022

Why and how to anneal 3D printed plastic parts and how to build precision 3D-print annealing oven Note: This page is still under work and changes will show up frequently. PLA is the most common filament materials for 3D printing but like all kinds of polymers…

Prima Select MP120 3D Printer modifications.

Posted on December 5, 2021 by gregganJuly 18, 2022

Prima Select MP120 Modified with belted Z-axis This will be the start of this project I will list the whole plan further down this page. Up to know I’m done with the Z-axis and have installed a MKS Robin min V1.2 controller board and TMC2208…

↑

stockholmviews.com

DIY photography, IOT, Arduino, ESP, Range Rover P38's and much more.

Category Archives: 3D Printers

3D printer hardware test board build

Bondtech V2 inspired “bowden” extruder THE OXtruder

3D print annealing of PLA and HT-PLA

Prima Select MP120 3D Printer modifications.